Direct and indirect electrochemical reduction prior to a biological treatment for dimetridazole removal.

Two different electrochemical reduction processes for the removal of dimetridazole, a nitroimidazole-based antibiotic, were examined in this work. A direct electrochemical reduction was first carried out in a home-made flow cell in acidic medium at potentials chosen to minimize the formation of amino derivatives and then the formation of azo dimer. Analysis of the electrolyzed solution showed a total degradation of dimetridazole and the BOD5/COD ratio increased from 0.13 to 0.24. An indirect electrochemical reduction in the presence of titanocene dichloride ((C5H5)2TiCl2), which is used to reduce selectively nitro compounds, was then investigated to favour the formation of amino compounds over hydroxylamines and then to prevent the formation of azo and azoxy dimers. UPLC-MS/MS analyses showed a higher selectivity towards the formation of the amino compound for indirect electrolyses performed at pH 2. To confirm the effectiveness of the electrochemical reduction, a biological treatment involving activated sludge was then carried out after direct and indirect electrolyses at different pH. The enhancement of the biodegradability was clearly shown since mineralization yields of all electrolyzed solutions increased significantly.

A sequential procedure for rapid and accurate identification of putative trichomonacidal agents.

In the current report, a sequential step-wise methodology based on in silico, in vitro and in vivo experimental procedures for the prompt detection of potential trichomonacidal drugs is proposed. A combinatorial of 12 QSAR (Quantitative Structure-Activity Relationship) models based on Linear Discrimination Analysis (LDA) are suggested for the rational identification of new trichomonacidal drugs from virtual screening of in house chemical libraries and drug databases. Subsequently, compounds selected as potential anti-trichomonas are screened in vitro against Trichomonas vaginalis. Finally, molecules with specific trichomonacidal activity are evaluated in vivo. Herein, different molecules were exposed to the proposed methodology. Firstly, the agents were virtually screened and two of the eight molecules (G-1 and dimetridazole) were classified as trichomonacidals by the 12 models. Subsequently both drugs were proved in vitro and in vivo following the workflow procedure. Although a remarkable in vitro activity was observed in both cases, dimetridazole achieved higher MIC100 activity than metronidazole against the resistant isolate. Furthermore, the in vivo models showed a remarkable reduction of lesions of more than 55% in both compounds. These observations support the current flowchart screening and suggest the use of dimetridazole as a promising drug-like scaffold for novel therapeutic alternatives against T. vaginalis resistant infections.

Preparation and characterization of a molecularly imprinted monolithic column for pressure-assisted CEC separation of nitroimidazole drugs.

A polymethacrylate-based molecularly imprinted monolithic column bearing mixed functional monomers, using non-covalent imprinting approach, was designed for the rapid separation of nitroimidazole compounds. The new monolithic column has been prepared via simple in situ polymerization of 2-hydroxyethyl methacrylate, dimethylaminoethyl methacrylate and ethylene dimethacrylate, using (S)-ornidazole ((S)-ONZ) as template in a binary porogenic mixture consisting of toluene and dodecanol. The composition of the polymerization mixture was systematically altered and optimized by altering the amount of monomers as well as the composition of the porogenic solvent. The column performance was evaluated in pressure-assisted CEC mode. Separation conditions such as pH, voltage, amount of organic modifier and salt concentration were studied. The optimized monolithic column resulted in excellent separation of a group of structurally related nitroimidazole drugs within 10 min in isocratic elution condition. Column efficiencies of 99 000, 80 000, 103 000, 60 000 and 99 000 plates/m were obtained for metronidazole, secnidazole, ronidazole, tinidazole and dimetridazole, respectively. Parallel experiments were carried out using molecularly imprinted and non-imprinted capillary columns. The separation might be the result of combined effects including hydrophobic, hydrogen bonding and the imprinting cavities on the (S)-ONZ-imprinted monolithic column.