Topography and functional information of plasma membrane.

By using atomic force microscope (AFM), the topography and function of the plasmalemma surface of the isolated protoplasts from winter wheat mesophyll cells were observed, and compared with dead protoplasts induced by dehydrating stress. The observational results revealed that the plasma membrane of living protoplasts was in a state of polarization. Lipid layers of different cells and membrane areas exhibited distinct active states. The surfaces of plasma membranes were unequal, and were characterized of regionalisation. In addition, lattice structures were visualized in some regions of the membrane surface. These typical structures were assumed to be lipid molecular complexes, which were measured to be 15.8+/-0.09 nm in diameter and 1.9+/-0.3 nm in height. Both two-dimensional and three-dimensional imaging showed that the plasmalemma surfaces of winter wheat protoplasts were covered with numerous protruding particles. In order to determine the chemical nature of the protruding particles, living protoplasts were treated by proteolytic enzyme. Under the effect of enzyme, large particles became relatively looser, resulting that their width was increased and their height decreased. The results demonstrated that these particles were likely to be of protein nature. These protein particles at plasmalemma surface were different in size and unequal in distribution. The diameter of large protein particles ranged from 200 to 440 nm, with a central micropore, and the apparent height of them was found to vary from 12 to 40 nm. The diameter of mid-sized protein particles was between 40-60 nm, and a range of 1.8-5 nm was given for the apparent height of them. As for small protein particles, obtained values were 12-40 nm for their diameter and 0.7-2.2 nm for height. Some invaginated pits were also observed at the plasma membrane. They were formed by the endocytosis of protoplast. Distribution density of them at plasmalemma was about 16 pits per 15 microm(2). According to their size, we classified the invaginated pits into two types--larger pits measuring 139 nm in diameter and 7.2 nm in depth, and smaller pits measuring 96 nm in diameter and 2.3 nm in depth. On dehydration-induced dead protoplasts, the degree of polarization of plasma membranes decreased. Lipid molecular layers appeared relatively smooth, and the quantity of integral proteins reduced a lot. Invaginated pits were still detectable at the membrane surface, but due to dehydration-induced protoplast contraction, the orifice diameter of pits reduced, and their depth increased. Larger pits averagely measuring 47.4 nm in diameter and 31.9 nm in depth, and smaller pits measuring 26.5 nm in diameter and 43 nm in depth at average. The measured thickness of plasma membranes of mesophyll cells from winter wheat examined by AFM was 6.6-9.8 nm, thicker in regions covered with proteins.

Prion protein helix1 promotes aggregation but is not converted into beta-sheet.

Prion diseases are caused by the aggregation of the native alpha-helical prion protein PrP(C) into its pathological beta-sheet-rich isoform PrP(Sc). In current models of PrP(Sc), helix1 is assumed to be preferentially converted into beta-sheet during aggregation of PrP(C). This was supported by the NMR structure of PrP(C) since, in contrast to the isolated helix1, helix2 and helix3 are connected by a small loop and are additionally stabilized by an interhelical disulfide bond. However, helix1 is extremely hydrophilic and has a high helix propensity. This prompted us to investigate the role of helix1 in prion aggregation using humPrP(23-159) including helix1 (144-156) compared with the C-terminal-truncated isoform humPrP(23-144) corresponding to the pathological human stop mutations Q160Stop and Y145Stop, respectively. Most unexpectedly, humPrP(23-159) aggregated significantly faster compared with the truncated fragment humPrP(23-144), clearly demonstrating that helix1 is involved in the aggregation process. However, helix1 is not resistant to digestion with proteinase K in fibrillar humPrP(23-159), suggesting that helix1 is not converted to beta-sheet. This is confirmed by Fourier transformation infrared spectroscopy since there is almost no difference in beta-sheet content of humPrP(23-159) fibrils compared with humPrP(23-144). In conclusion, we provide strong direct evidence that in contrast to earlier assumptions helix1 is not converted into beta-sheet during aggregation of PrP(C) to PrP(Sc).

The adjacent flanking region plays a critical role in facilitating the presentation of the Listeria monocytogenes product lemA to H2 M3wt-restricted, peptide-specific murine CD8 cells.

Mice infected with Listeria monocytogenes (LM) generate CD8 effectors specific for f-MIGWII, the amino terminus of the bacterial product lemA presented by the class Ib MHC molecule H2 M3wt. lemA has several distinctive properties: 1) it is readily presented as an exogenous Ag in the absence of bacterial infection; 2) it is processed by a TAP-independent pathway, which is sensitive to chloroquine, pepstatin, and brefeldin; and 3) the immunogenic portion of the molecule is extremely resistant to proteolytic degradation even by proteinase K. To assess the structural basis for these findings, we expressed a truncated variant (t-lemA) containing the amino-terminal hexapeptide and the subsequent 27 amino acids linked to a histidine tail in Escherichia coli, and purified the product by affinity chromatography. Purified t-lemA could be presented to f-MIGWII-specific effectors by macrophages and fibroblasts at 1-10 nM. Unlike f-MIGWII, which binds directly to H2 M3wt, t-lemA required processing by a chloroquine-, pepstatin-, and brefeldin-sensitive pathway. Brefeldin sensitivity often implies endogenous processing in the cytoplasm, but several lines of evidence suggest translocation to the cytoplasm and proteosomal degradation are not critical for t-lemA presentation. Unlike f-MIGWII, t-lemA was profoundly resistant to proteinase K, and, using 35S-labeled t-lemA, we could identify the region from position 1 to approximately 30 as the protease-resistant element. Thus, the hydrophobic peptide sequence following f-MIGWII can account for the unusual properties of lemA noted above. Analogous modification could be used to alter the properties of other peptide Ags presented by class I MHC products.