Cavity preparation devices: effect on microleakage of Class V resin-based composite restorations.

ABSTRACT

PURPOSE: To evaluate the effect of cavity preparation device (i.e. carbide bur, diamond bur, air abrasive, Sonicsys, and ErYAG laser) on microleakage of Class V resin-based composite (RBC) restorations, the tooth restoration interface and dentin ultrastructure. MATERIALS AND METHODS: Eight groups (n=18) of 9 human molars each were prepared on the buccal and lingual surfaces for Class V RBC restorations using five preparation devices Group 1 carbide bur #8 round; Group 2 diamond bur #801; Group 3 KCP 1000 air abrasion unit; Group 4 Sonicsys Approx.; Group 5 ErYAG laser; Group 6 carbide bur plus air abrasive; Group 7 carbide bur plus laser, and Group 8 laser without etching. Circular cavity preparations, 3 mm diameter and 1.5 mm deep, were cut at the CEJ on the buccal and lingual surfaces of each tooth. A bevel was placed on the enamel margin. All cavities were restored using Single Bond adhesive system and Silux Plus according to manufacturer's directions, with the exception that no etchant was used with Group 8. After thermocycling, specimens were tested for microleakage using silver nitrate methodology. Dye penetration data was collected and subjected to non-parametric statistical analysis. SEM analysis of the dentin-RBC interface, as well as the effect of each cavity preparation device on the surface of dentin was performed. RESULTS: Microleakage did not occur in enamel for any method of cavity preparation when the enamel was etched prior to adhesive application. Kruskal-Wallis One-way ANOVA revealed differences in dentin microleakage among the tested groups at alpha=0.05. Mann-Whitney Test for Paired Comparisons at alpha=0.01 demonstrated significantly greater dentin microleakage in Groups 5 and 7 compared to all groups except Group 3 (air abrasive). Although Group 8 had the least microleakage in dentin, this was not significantly different from Groups 1, 2, 4 and 6. SEM observation revealed hybridization at the dentin-resin interface for all groups except for Group 8 (laser prepared, non-etched). Surface analysis showed differences related to the operating mode of each preparation device. CLINICAL SIGNIFICANCE: The method of cavity preparation did not affect microleakage in etched enamel. When using a laser for cavity preparation, enamel should be etched although not etching dentin may help to improve marginal seal.