The usability of green deep eutectic solvents in hollow fiber Liquid-Phase microextraction for the simultaneous extraction of analytes of different Natures: A comprehensive study.

ABSTRACT

In the current study, a wide range of deep eutectic solvents (DESs) with different properties (hydrophilic, hydrophobic, ionic, and nonionic) were prepared in the initial phase. Subsequently, an assessment was conducted to evaluate some characteristics of the produced DESs, including their stability at room temperature and their capacity to extract three distinct types of analytes (anionic, cationic, and non-ionic) simultaneously through hollow fiber-liquid phase microextraction (HF-LPME) technique. To carry out the extraction procedure, the prepared DESs were inserted into the pores (as supported liquid membrane (SLM)) and lumen of hollow fiber membrane (HF) to apply two-phase and three-phase HF-LPME techniques. After a thorough evaluation, the three-phase HF-LPME technique (HF(3)-LPME) was chosen by using a mixture of menthol/TBAB-based hydrophobic DES (DES-35) as SLM and the mixture of malic acid/citric acid/water-based hydrophilic DES (DES-2) as an extraction solvent in the lumen of HF. All factors affecting the extraction recovery (including pH, extraction time, extraction temperature, stirring speed, and salt effect) were optimized utilizing the one-variable-at-a-time (OVAT) methodology. After applying the extraction procedure, all extracted samples were analyzed using the UV-Vis spectrometer and results were recorded at different wavelengths including 655 nm for Methylene blue, 550 nm for Amaranth, and 375 nm for Quercetin. The calibration graphs showed linearity in the range of 20.0-1500 µg/L, with a limit of detection of 6.2-15.1 µg/L and correlation coefficients higher than 0.9913 for the studied analytes. Moreover, the intra-day RSD, inter-day RSD, preconcentration factor (PF), enrichment factors (EF), and extraction recoveries (ER%) were obtained in the range of 3.1-4.8, 3.8-6.7, 125, 102.9-111.4, and 82.3-89.1 %, respectively. The use of the selected DES in the HF-LPME methodology resulted in an ecologically friendly strategy, as evidenced by the use of green metrics from the SPMS tool. The proposed strategy is also considered environmentally friendly due to its use of minimal solvents, waste reduction, and low energy consumption. The proposed technique effectively and simultaneously extractedmethylene blue, amaranth, and quercetin analytes in different real samples.