First Report of White Mold Caused by Sclerotinia sclerotiorum on Hymenocallis glauca in Mexico.

ABSTRACT

In Mexico, there are 29 native species of the genus Hymenocallis, where H. glauca is one of the most cultivated bulbous plants. It holds economic importance as it is commercialized as a potted plant and cut flower (Leszczyñska and Borys, 2001). In October 2023, field sampling was conducted in the Research Center in Horticulture and Native Plants (18°55'55" N, 98°24'02.8"W) of UPAEP University. H. glauca diseased plants were found in an area of 0.4 ha, with an incidence of 35% and an estimated severity of 45% on infected plants in vegetative stage. The symptoms included chlorosis of foliage, necrosis at the base of the stem, and soft rot with abundant white to gray mycelium and abundant production of black, irregular sclerotia of approximately 3.5 mm diameter. Finally, the plants wilted and died. The fungus was isolated from 40 symptomatic plants. Sclerotia were collected, disinfested with 3% NaOCl for one minute, rinsed with sterile distilled water (SDW), and plated on Petri dishes containing potato dextrose agar (PDA) with sterile forceps. Subsequently, a sterile dissecting needle was used to place fragments of mycelium directly on Petri dishes with PDA. Plates were incubated at 23 °C in dark for 7 days. One isolate was obtained from each diseased plant by the hyphal-tip method (20 isolates from sclerotia and 20 from mycelium). After 7 days, colonies had fast-growing, dense, and cottony-white aerial mycelium forming irregular sclerotia of 3.57 ± 0.59 mm (mean ± standard deviation, n=100). In each Petri dish there were produced 21.5 ± 7.9 sclerotia (mean ± standard deviation, n=40), after 11 days; these were initially white and gradually turned black. The isolates were tentatively identified as Sclerotinia sclerotiorum based on morphological characteristics (Saharan and Mehta 2008). Two representative isolates were chosen for molecular identification and genomic DNA was extracted by the CTAB protocol. The ITS region and the glyceraldehyde 3-phosphate dehydrogenase (G3PDH) gene were amplified and sequenced (Staats et al. 2005; White et al. 1990). The sequences of a representative isolate (SsHg3) were deposited in GenBank (ITS- PP094578; G3PDH- PP101843). BLAST analysis of the partial sequences ITS (519 bp), and G3PDH (950 bp) showed 100% similarity to S. sclerotiorum isolates (GenBank MG249967, MW082601). Pathogenicity was confirmed by inoculating 30 H. glauca plants in vegetative stage grown in pots with sterile soil. Ten sclerotia were deposited at the base of the stem, 10 mm below the soil surface. As control treatment, SDW was applied to 10 plants. The plants were placed in a greenhouse at 23 °C and 90% relative humidity. After 17 days, all inoculated plants displayed symptoms similar to those observed in the field, while no symptoms were observed on the controls. The fungus was re-isolated from the inoculated plants as described above, fulfilling Koch's postulates. The pathogenicity tests were repeated three times. S. sclerotiorum has been reported causing white mold on other bulbous plants, like fennel (Foeniculum vulgare) in Korea (Choi et al. 2015). To our knowledge, this is the first report of S. sclerotiorum causing white mold on H. glauca in Mexico. Information about diseases affecting this plant is very limited, so this research is essential for developing integrated management strategies and preventing spread to other production areas.