Development of Three-Layered Composite Color Converters for White LEDs Based on the Epitaxial Structures of YAG:Ce, TbAG:Ce and LuAG:Ce Garnets.

This work was dedicated to the development of novel types of composite phosphor converters of white LED, based on the epitaxial structures containing Y3Al5O12:Ce (YAG:Ce) and Tb3Al5O12:Ce (TbAG:Ce) single crystalline films, steeply grown, using the liquid-phase epitaxy method, onto LuAG:Ce single crystal substrates. The influence of Ce3+ concentration in the LuAG:Ce substrate, as well as the thickness of the subsequent YAG:Ce and TbAG:Ce films, on the luminescence and photoconversion properties of the three-layered composite converters were investigated. Compared to its traditional YAG:Ce counterpart, the developed composite converter demonstrates broadened emission bands, due to the compensation of the cyan-green dip by the additional LuAG:Ce substrate luminescence, along with yellow-orange luminescence from the YAG:Ce and TbAG:Ce films. Such a combination of emission bands from various crystalline garnet compounds allows the production of a wide emission spectrum of WLEDs. In turn, the variation in the thickness and activator concentration in each part of the composite converter allows the production of almost any shade from green to orange emission on the chromaticity diagram.

Single Crystalline Films of Ce3+-Doped Y3MgxSiyAl5-x-yO12 Garnets: Crystallization, Optical, and Photocurrent Properties.

This research focuses on LPE growth, and the examination of the optical and photovoltaic properties of single crystalline film (SCF) phosphors based on Ce3+-doped Y3MgxSiyAl5-x-yO12 garnets with Mg and Si contents in x = 0-0.345 and y = 0-0.31 ranges. The absorbance, luminescence, scintillation, and photocurrent properties of Y3MgxSiyAl5-x-yO12:Ce SCFs were examined in comparison with Y3Al5O12:Ce (YAG:Ce) counterpart. Especially prepared YAG:Ce SCFs with a low (x, y < 0.1) concentration of Mg2+ and Mg2+-Si4+ codopants also showed a photocurrent that increased with rising Mg2+ and Si4+ concentrations. Mg2+ excess was systematically present in as-grown Y3MgxSiyAl5-x-yO12:Ce SCFs. The as-grown SCFs of these garnets under the excitation of α-particles had a low light yield (LY) and a fast scintillation response with a decay time in the ns range due to producing the Ce4+ ions as compensators for the Mg2+ excess. The Ce4+ dopant recharged to the Ce3+ state after SCF annealing at T > 1000 °C in a reducing atmosphere (95%N2 + 5%H2). Annealed SCF samples exhibited an LY of around 42% and similar scintillation decay kinetics to those of the YAG:Ce SCF counterpart. The photoluminescence studies of Y3MgxSiyAl5-x-yO12:Ce SCFs provide evidence for Ce3+ multicenter formation and the presence of an energy transfer between various Ce3+ multicenters. The Ce3+ multicenters possessed variable crystal field strengths in the nonequivalent dodecahedral sites of the garnet host due to the substitution of the octahedral positions by Mg2+ and the tetrahedral positions by Si4+. In comparison with YAG:Ce SCF, the Ce3+ luminescence spectra of Y3MgxSiyAl5-x-yO12:Ce SCFs greatly expanded in the red region. Using these beneficial trends of changes in the optical and photocurrent properties of Y3MgxSiyAl5-x-yO12:Ce garnets as a result of Mg2+ and Si4+ alloying, a new generation of SCF converters for white LEDs, photovoltaics, and scintillators could be developed.

Development of the Composite Thermoluminescent Detectors Based on the Single Crystalline Films and Crystals of Perovskite Compounds.

This work is dedicated to the development of new types of composite thermoluminescent detectors based on the single crystalline films of Ce-doped GdAlO3 perovskite and Mn-doped YAlO3 and (Lu0.8Y0.2)AlO3:Mn perovskites as well as Ce and Pr-doped YAlO3 single crystal substrates. These detectors were obtained using the Liquid Phase Epitaxy growth method from the melt solution based on the PbO-B2O3 fluxes. Such composite detectors can by applied for the simultaneous registration of different components of mixed ionization fluxes using the differences between the thermoluminescent glow curves, recorded from the film and crystal parts of epitaxial structures. For creation of the new composite detectors, we considered using, for the film and crystal components of epitaxial structures (i) the different perovskite matrixes doped with the same type of activator or (ii) the same perovskite host with various types of activators. The thermoluminescent properties of the different types of epitaxial structures based on the abovementioned films and crystal substrates were examined in the conditions of ß-particles and X-ray excitation with aim of determination of the optimal combination of perovskites for composite detectors. It was shown that, among the structures with all the studied compositions, the best properties for the simultaneous thermoluminescent detection of α- and X-rays were the GdAlO3:Ce film/YAlO3:Ce crystal epitaxial structure.

Application of the LPE-Grown LuAG: Ce Film/YAG Crystal Composite Thermoluminescence Detector for Distinguishing the Components of the Mixed Radiation Field.

Single-crystalline films (SCFs) of the LuAG: Ce garnet grown using the liquid-phase epitaxy method onto YAG single-crystal (SC) substrates were investigated for possible applications as composite thermoluminescent (TL) detectors. Such detectors may help to register the different components of ionizing radiation fields with various penetration depths, e.g., heavy charged particles and gamma or beta rays. It was found that the TL signal of LuAG: Ce SCF sufficiently differs from that of the YAG substrate concerning both the temperature and wavelength of emissions. Furthermore, even by analyzing TL glow curves, it was possible to distinguish the difference between weakly and deeply penetrating types of radiation. Within a test involving the exposure of detectors with the mixed alpha/beta radiations, the doses of both components were determined with an accuracy of a few percent.

In silico Raman spectroscopy of YAlO3 single-crystalline film.

The Raman response of the YAlO3 (YAP) perovskite is modeled by means of periodic density functional theory. A number of different approximations to the exchange-correlation functional are benchmarked against the structural and spectroscopic data as imposing all-electron Gaussian-type basis sets. The WC1LYP functional was found to be superior, particularly outperforming other tested approaches in the prediction of the local structure of the AlO subunits, which reflects in the observed lattice-dynamics. The Raman response is further decomposed into the directional spectra, which are due to different components of the polarizability tensor, and confronted with the experimental Raman spectra, recorded in different scattering geometries of the single-crystalline film of YAP. The in silico lattice dynamics provides the unequivocal assignment of the observed bands with an excellent match to the experimental spectra, allowing for a complete analysis of the underlying phonon modes in terms of their energy, symmetry and the directional activity. The presented analysis serves as a high-quality reference, potentially useful in the future studies of other YAP materials, where Raman spectroscopy along with the X-Ray diffraction is the first method of choice.