Mortar Bond Strength: A Brief Literature Review, Tests for Analysis, New Research Needs and Initial Experiments.

Despite technological advances in the production processes of the materials for ceramic façade coatings, the problems of detachments are still frequent. Therefore, this work aims to investigate, through a literature review, the existing gaps related to the adhesion ability of adhesive mortars, identifying new research needs that can better explain the behavior of the material. In addition, an experimental procedure was developed to evaluate the mechanical capacity of adhesive mortars when subjected to cyclic stresses. Dynamic stress measurements are presented for several blocks of mortar and on similar blocks but with a slot drilled prior to measurements (intended to represent failure). From these data we calculated values of stress energy, elastic energy, and dissipated energy. The experimental results showed that the energy involved in the test process accompanied the load values and current stress values. The mortar samples with the previous failure absorbed and dissipated less energy than mortars without failure, showing that materials that have less energy to dissipate, are materials that have developed less capacity to adhere, that is, to keep their parts together.

The Influence of Lime Solution in Kneading Water Substitution on Cement Roughcast and Mortar Coating.

The understanding of the mechanical fixation behavior of coatings is crucial for a better comprehension of the bonding systems, especially at the interface between the mortar and the substrate. Physical adherence is related, among other things, to the contents of the materials used in the roughcast and mortar coatings, due to the colloidal water penetration into the pores of the substrate. This work evaluated the influence of different lime solution additions replacing the kneading water in the preparation of roughcast and mortar coatings. Two types of substrates were investigated:ceramic bricks and concrete blocks. Three wall masonry panels were constructed, with dimensions of 220 × 180 cm2, one of concrete block and two of ceramic bricks, followed by the application of roughcast and mortar coating with an average thickness of 5 mm and 20 mm, respectively. Direct tensile bond strength tests were performed and the results, with a 95% confidence level, showed that substrate ceramic and treatment in the roughcast exhibited a better behavior regarding the distribution of the tensile bond strength of the tested specimens. However, no significant differences of the amount of addition used (0%, 5%, 10% and 15%) on the tensile bond strength were observed.

Fast dye removal from water by starch-based nanocomposites.

Robust and efficient methylene blue (MB) adsorbent was prepared based on starch/cellulose nanowhiskers hydrogel composite. Maximum MB adsorption capacity of ∼2050mgperg of dried hydrogel was obtained with the composite at 5wt.% of cellulose nanowhiskers and at pH 5. Adsorption capacity varied from 1450mg/g to 2050mg/g with increasing the initial MB concentration from 1500mg/L to 2500mg/L, respectively. For all the concentrations studied ca. 90% of MB was removed by the adsorbent. Optimal conditions were obtained at pH⩾5 due to the generation of negatively charged groups (COO(-)) in the adsorbent, which can strongly interact with the positive charges from MB. The main advantage of this system over other reported adsorbents, besides the fact of being synthesized from biodegradable polymers (starch and cellulose), is its fast adsorption kinetics that follows the pseudo-second order model, which is based on chimisorption phenomenon. Saturation condition was reached as fast as 1h of experiments owing to the formation of an adsorbed MB monolayer as suggested by the Langmuir isotherm model. Desorption experiments showed 60wt.% of MB loaded can be removed from the adsorbent by immersing it in a pH 1 solution, showing its feasibility to be reused. Therefore, starch/cellulose nanowhiskers hydrogel composite presents outstanding capacity to be employed in the remediation of MB contaminated wastewaters.

Transformar las organizaciones de salud por la calidad: guia para el lider en el proceso de cambio / Changing health organizations by quality

Coleçäo de experiências direcionadas aos profissionais da saúde (médicos, enfermeiros, farmacêuticos, administradores e outros)que iniciam processo de gestäo de qualidade em suas organizaçöes, ou que necessitam de suporte para a administraçäo de uma área especial em determinada organizacäo de saúde. Trata de temas como: o processo de gestäo de qualidade em uma organizaçäo de assistência à saúde, o significado de gestäo de qualidade, as ferramentas da gestäo de qualidade, reestruturaçäo das organizaçöes para a qualidade, suporte aos recursos humanos na gestäo de qualidade