DABCOnium: An Efficient and High-Voltage Stable Singlet Oxygen Quencher for Metal-O2 Cells.

Singlet oxygen (1 O2 ) causes a major fraction of the parasitic chemistry during the cycling of non-aqueous alkali metal-O2 batteries and also contributes to interfacial reactivity of transition-metal oxide intercalation compounds. We introduce DABCOnium, the mono alkylated form of 1,4-diazabicyclo[2.2.2]octane (DABCO), as an efficient 1 O2 quencher with an unusually high oxidative stability of ca. 4.2 V vs. Li/Li+ . Previous quenchers are strongly Lewis basic amines with too low oxidative stability. DABCOnium is an ionic liquid, non-volatile, highly soluble in the electrolyte, stable against superoxide and peroxide, and compatible with lithium metal. The electrochemical stability covers the required range for metal-O2 batteries and greatly reduces 1 O2 related parasitic chemistry as demonstrated for the Li-O2 cell.

Singlet Oxygen during Cycling of the Aprotic Sodium-O2 Battery.

Aprotic sodium-O2 batteries require the reversible formation/dissolution of sodium superoxide (NaO2 ) on cycling. Poor cycle life has been associated with parasitic chemistry caused by the reactivity of electrolyte and electrode with NaO2 , a strong nucleophile and base. Its reactivity can, however, not consistently explain the side reactions and irreversibility. Herein we show that singlet oxygen (1 O2 ) forms at all stages of cycling and that it is a main driver for parasitic chemistry. It was detected in- and ex-situ via a 1 O2 trap that selectively and rapidly forms a stable adduct with 1 O2 . The 1 O2 formation mechanism involves proton-mediated superoxide disproportionation on discharge, rest, and charge below ca. 3.3 V, and direct electrochemical 1 O2 evolution above ca. 3.3 V. Trace water, which is needed for high capacities also drives parasitic chemistry. Controlling the highly reactive singlet oxygen is thus crucial for achieving highly reversible cell operation.

An Electrolyte for Reversible Cycling of Sodium Metal and Intercalation Compounds.

Na battery chemistries show poor passivation behavior of low voltage Na storage compounds and Na metal with organic carbonate-based electrolytes adopted from Li-ion batteries. Therefore, a suitable electrolyte remains a major challenge for establishing Na batteries. Here we report highly concentrated sodium bis(fluorosulfonyl)imide (NaFSI) in dimethoxyethane (DME) electrolytes and investigate them for Na metal and hard carbon anodes and intercalation cathodes. For a DME/NaFSI ratio of 2, a stable passivation of anode materials was found owing to the formation of a stable solid electrolyte interface, which was characterized spectroscopically. This permitted non-dentritic Na metal cycling with approximately 98 % coulombic efficiency as shown for up to 300 cycles. The NaFSI/DME electrolyte may enable Na-metal anodes and allows for more reliable assessment of electrode materials in Na-ion half-cells, as is demonstrated by comparing half-cell cycling of hard carbon anodes and Na3 V2 (PO4 )3 cathodes with a widely used carbonate and the NaFSI/DME electrolyte.