ABSTRACT
This study utilized a colorimeter to determine the color values of 23 beauty tea (BT) samples, the color and the taste characteristics were also quantitatively described through ultraviolet-visible (UV-Vis) spectroscopy and taste equivalent quantification. Furthermore, metabolomic analysis was conducted by using ultra-high-performance liquid chromatography-mass spectrometry (UPLC-MS). Correlation analysis was employed to preliminarily identify the compounds that contribute to the color and taste of BT infusion. Finally, the contributing compounds were further determined through verification experiment. The results showed that within a certain range, as the color of BT infusion deepened, the taste became stronger, more bitter and astringent, while on the contrary, it became sweeter and mellower. Theaflavins, kaempferol, astragalin, and 5-p-coumaroylquinic acid influenced both the color and taste of the BT infusion. Gallic acid was also determined as a contributor to the color. This study provides new insights into research on tea quality in infusion color and taste aspects.
ABSTRACT
BACKGROUND: Withering is the first processing procedure of beauty tea, and there are few reports on the impact of withering methods on the quality of beauty tea and its regulatory mechanisms. RESULTS: Through comparison of fresh tea leaves (FT) with the leaves after indoor natural withering for 18 h (IWT-18) and outdoor solar withering for 6 h (OWT-6), which were collected at the end of the two withering processes, 17 282 and 13 984 differentially expressed genes (DEGs) were respectively screened and 267 and 154 differential metabolites (DMs) were respectively identified. The coexpression network revealed that a large number of DEGs and DMs were enriched in phenylpropanoid, flavonoid, and adenosine triphosphate binding cassette (ABC) transporter pathways, and the number of DMs and DEGs in IWT-18 versus FT exceeded that in OWT-6 versus FT. Both withering methods promoted a significant increase in content of phenylalanine and upregulation of ß-glucoside expression in the phenylpropanoid metabolism pathway. Five theaflavin-type proanthocyanidins in the flavonoid synthesis pathway were more significantly accumulated in FT versus IWT-18 than in FT versus OWT-6. Meanwhile, both withering methods can affect the ABC transporter pathway to promote the accumulation of amino acids and their derivatives, but different withering methods affect different ABC transporter families. Outdoor withering with more severe abiotic stress has a greater impact on the ABCG family, whereas indoor withering has a more significant effect on the ABCC family. Sensory evaluation results showed that the dry tea of IWT-18 was slightly better than that of OWT-6 because of the longer withering time and more thorough substance transformation. CONCLUSION: In conclusion, the formation of honey flavor in beauty tea may be closely related to the DEGs and DMs in these three pathways. Our research provides theoretical data support for further revealing the mechanism of quality formation during the withering process of beauty tea. © 2023 Society of Chemical Industry.
Subject(s)
Camellia sinensis , Camellia sinensis/chemistry , Transcriptome , Beauty , Metabolome , Flavonoids/analysis , Tea/chemistry , ATP-Binding Cassette Transporters/genetics , ATP-Binding Cassette Transporters/analysis , ATP-Binding Cassette Transporters/metabolism , Plant Leaves/chemistryABSTRACT
The fresh leaves were processed into beauty tea from the Camellia sinensis "Jinxuan" cultivar, which were punctured by tea green leafhoppers to different extents. Low-puncturing dry tea (LPDT) exhibited a superior quality. Altogether, 101 and 129 differential metabolites, including tea polyphenols, lipids, and saccharides, were identified from the fresh leaves and dry beauty tea, respectively. Most metabolite levels increased in the fresh leaves punctured by leafhoppers, but the opposite was observed for the dry beauty tea. According to relative odor activity values (rOAVs) and partial least-squares discriminant analysis (PLS-DA), four characteristic volatiles, including linalool, geraniol, benzeneacetaldehyde, and dihydrolinalool, were selected. Mechanical injury to leaves caused by leafhoppers, watery saliva secreted by the leafhopper, and different water contents of the fresh leaves in different puncturing degrees are the possible reasons for the difference in the quality of the beauty tea with different levels of puncturing. Overall, this study identified a wide range of chemicals that are affected by the degrees of leafhopper puncturing.
Subject(s)
Camellia sinensis , Hemiptera , Animals , Camellia sinensis/chemistry , Discriminant Analysis , Plant Leaves/chemistry , Tea/chemistryABSTRACT
Beauty tea with special flavor can be affected by the degree of leafhopper puncturing. The present research adopted widely targeted metabolomics to analyze the characteristic metabolites of fresh tea leaves and beauty tea with different degrees of leafhopper puncturing. Low-puncturing beauty tea (LPBT) exhibited a superior quality. Altogether, 95 and 65 differential metabolites, including tea polyphenols, saccharides, and lipids, were identified from fresh leaves and beauty tea, respectively. The partial least squares regression (PLSR) analysis results showed that isomaltulose, theaflavic acid, and ellagic acid, may be the characteristic metabolites that form the different taste outlines of beauty tea. Based on odor activity values (OAVs) and partial least squares discriminant analysis (PLS-DA), dihydrolinalool and cis-linalool oxide were identified as characteristic volatile components, which may be essential for the formation of the different aroma characteristic of beauty tea. The results provide a theoretical basis for selecting raw materials, performing quality research, and developing beauty tea industrially.
ABSTRACT
Tip-extending soft robots, taking flexible film or rubber as body material and fluid pressure as input power, exhibit excellent advantages in constrained and cluttered environments for detection and manipulation. However, existing soft continuum robots are of great challenges in achieving multiple, mutually independent, and on-demand active steering over a long distance without precise steering control. In this paper, we introduce a vine-like soft robot made up of a pressurized thin-walled vessel integrated with the high controllability of a control system with multiple degrees of freedom in three dimensions. Moreover, steering and kinematic models to relate the steering angle and robot length to the location of the robot tip are provided, and a dynamic finite element model for analyzing the motion of the spatial consecutive steering is established. We demonstrate the abilities of disinfection of the robot moving in a long and tortuous pipeline and detection in a multi-obstacle constrained environment. It is established that the robot exhibits great advantages in active consecutive steering over a long distance, high controllability in completing more complex path planning, and significant ability of carrying operational tools for ventilation pipeline disinfection and multi-obstacle detection. The bionic soft robot shows great promise for use in environment sensing, target detecting, and equipment servicing.