Sage, Rosemary, and Bay Laurel Hydrodistillation By-Products as a Source of Bioactive Compounds.

Essential oils from Mediterranean wild plants are widely used, but the hydrodistillation residues produced in parallel with these essential oils are significantly understudied and underexploited. Since there are only fragmentary data in the literature, we have, for the first time, systematically analyzed the chemical composition of the by-products obtained after hydrodistillation of sage, bay laurel, and rosemary leaves, i.e., hydrolates, water residues, and solid residues. The chemical composition of the hydrolates changed compared to their respective essential oils towards the dominance of more hydrophilic, oxygenated compounds, such as camphor in sage, 1,8-cineole in bay laurel, and berbenone in rosemary. However, some compounds, mostly sesquiterpenes, which were present in considerable amounts in essential oils, were absent or only present in very small amounts in the hydrolates. Furthermore, both the water and the solid residues were rich in polyphenols, such as procyanidins in bay laurel and rosmarinic acid in rosemary and sage. In conclusion, we demonstrate the valuable chemical composition of sage, rosemary, and bay laurel hydrodistillation by-products and discuss a wide range of their possible applications.

Essential Oils of Sage, Rosemary, and Bay Laurel Inhibit the Life Stages of Oomycete Pathogens Important in Aquaculture.

Saprolegnia parasitica, the causative agent of saprolegniosis in fish, and Aphanomyces astaci, the causative agent of crayfish plague, are oomycete pathogens that cause economic losses in aquaculture. Since toxic chemicals are currently used to control them, we aimed to investigate their inhibition by essential oils of sage, rosemary, and bay laurel as environmentally acceptable alternatives. Gas Chromatography-Mass Spectrometry (GC-MS) analysis showed that the essential oils tested were rich in bioactive volatiles, mainly monoterpenes. Mycelium and zoospores of A. astaci were more sensitive compared to those of S. parasitica, where only sage essential oil completely inhibited mycelial growth. EC50 values (i.e., concentrations of samples at which the growth was inhibited by 50%) for mycelial growth determined by the radial growth inhibition assay were 0.031-0.098 µL/mL for A. astaci and 0.040 µL/mL for S. parasitica. EC50 values determined by the zoospore germination inhibition assay were 0.007-0.049 µL/mL for A. astaci and 0.012-0.063 µL/mL for S. parasitica. The observed inhibition, most pronounced for sage essential oil, could be partly due to dominant constituents of the essential oils, such as camphor, but more likely resulted from a synergistic effect of multiple compounds. Our results may serve as a basis for in vivo experiments and the development of environmentally friendly methods to control oomycete pathogens in aquaculture.

Sage Extract as a Natural Source of Corrosion Inhibitor for Tinplate in 3.0% NaCl.

RESEARCH BACKGROUND: Due to the growing interest and attention of the world towards environmental problems and protection of environment, the worldwide demand for biodegradable and effective corrosion inhibitors for tinplate has grown. Considering the diversity of the structures of polyphenols that are present in sage extract, it represents a promising potential source of low-cost and effective biodegradable green corrosion inhibitor for tinplate in 3.0% sodium chloride solution which is evaluated in this study. EXPERIMENTAL APPROACH: Tafel polarisation and electrochemical impedance spectroscopy (EIS) at 25 °C have been used to evaluate the inhibitory activity of sage (Salvia officinalis L.) extract as a green inhibitor for the protection of tinplate from corrosion in 3.0% sodium chloride solution. RESULTS AND CONCLUSIONS: We used electrochemical impedance spectroscopy to show that sage extract could serve as an effective inhibitor (94.1%) of the corrosion of tinplate in 3.0% NaCl at a mass concentration of 0.2 mg/L and temperature of 25 °C. The results obtained from potentiodynamic polarisation reveal that the sage extract acts as a mixed type inhibitor, with inhibition efficiency up to 82.5%, and the inhibition efficiencies calculated from EIS are in close agreement with these results. Attenuated total reflection-Fourier transform infrared spectroscopy (ATR-FTIR) results indicated that the inhibitory effect of the sage extract is due to the presence of a passivation layer on the tinplate surface, which consists of organic compounds such as polyphenols. These results confirm that the sage extract is more efficient in inhibiting the corrosion of tinplate at a concentration of 0.2 mg/L than at higher concentrations. Also, it shows good inhibition of tinplate in 3.0% sodium chloride solution. NOVELTY AND SCIENTIFIC CONTRIBUTIONS: The exceptional corrosion inhibition potential of sage extract opens a door for its use and revalorization as a green corrosion inhibitor in the food industry.

Effect of Enzymatic, Ultrasound, and Reflux Extraction Pretreatments on the Chemical Composition of Essential Oils.

The effect of different hydrodistillation pretreatments, namely, reflux extraction, reflux extraction with the addition of cell wall-degrading enzymes, and ultrasound, on the yield and chemical composition of essential oils of sage, bay laurel, and rosemary was examined. All pretreatments improved essential oil yield compared to no-pretreatment control (40-64% yield increase), while the oil quality remained mostly unchanged (as shown by statistical analysis of GC-MS results). However, enzyme-assisted reflux extraction pretreatment did not significantly outperform reflux extraction (no-enzyme control), suggesting that the observed yield increase was mostly a consequence of reflux extraction and enzymatic activity had only a minute effect. Thus, we show that ultrasound and reflux extraction pretreatments are beneficial in the production of essential oils of selected Mediterranean plants, but the application of enzymes has to be carefully re-evaluated.

Ultrasound assisted extraction and characterization of pectin from tomato waste.

Pectin was extracted from tomato waste using two different extraction methods to assess its potential utilization as an alternative source of commercial pectin production. Tomato waste was treated with ammonium oxalate/oxalic acid by conventional extraction (CE), under reflux and ultrasound assisted extraction (UAE) at 37 kHz and temperatures of 60 °C and 80 °C. The pectin obtained from these methods was analysed and compared in terms of yield, chemical properties and structure. Among examined methods, CE at 60 °C resulted with the highest yield, but UAE during 15 min of sonication produced the pectin of better quality (anhydrouronic acid, methoxy and calcium pectate contents and degree of esterification). NMR and FTIR spectroscopy of isolated pectins revealed predominantly esterified structure, irrespective of extraction conditions. The comparison of the pectin yields obtained after extraction at 80 °C, indicate that similar values were found at times of 24h and 15 min for CE and UAE, respectively. According to obtained results it can be concluded that main advantage of UAE is considerable shortening of extraction procedure with strong emphasis on environmental friendly processing approach. Therefore, these results suggested that UAE could be used as an efficient technique for the extraction of pectin from tomato waste and by-products.