Life cycle cost and environmental assessment for resource-oriented toilet systems.

The rich content of nutrients in human waste provides an outlook for turning it from pollutants to potential resources. The pilot-scale resource-oriented toilet with forward osmosis technology was demonstrated to have advantages to recover clean water, nitrogen, phosphorus, potassium, biogas, and heat from urine and feces. For the possibility of further full-scale implementation in different scenarios, six resource-oriented toilet systems and one conventional toilet system were designed in this study. The methodology of cost-benefit analysis and life cycle assessment were applied to analyze the life cycle economic feasibility and environmental sustainability of these systems. As results indicated, resource-oriented toilets with forward osmosis technology concentrating urine proved to have both economic and environmental benefit. The economic net present value results of new resource-oriented toilets were much better than conventional toilet. The energy consumption in resource-oriented toilets contributes a lot to the environmental impacts while resource recovery such as the fertilizer production and fresh water harvest in resource-oriented toilet systems offsets a lot. Taking both life cycle economic feasibility and environmental sustainability into consideration, the partial resource-oriented toilet (only recovering nutrients from urine) is the best choice, and the totally independent resource-oriented toilet could be applied to replace conventional toilets in areas without any external facilities such as sewer and water supply system etc.

Chemical toxicity and ecotoxicity evaluation of tannery sludge stabilized with ladle furnace slag.

In this study, the stabilization of tannery sludge, which produced during the physico-chemical treatment of tannery wastewaters, was examined by the addition of ladle furnace slag. Moreover, the simultaneous addition of organoclay and ladle furnace slag for the stabilization of tannery sludge was also examined. Chromium and dissolved organic carbon in the leachate of raw tannery sludge, using the EN 12457-2 standard leaching test, were found to exceed the limit values for disposal in non-hazardous and even in hazardous waste landfills, according to the EU Decision 2003/33/EC. Tannery waste (air-dried sludge) was mixed with ladle furnace slag and water or ladle furnace slag, organoclay and water at different ratios, in order to study the stabilization of chromium and organic compounds. The mixtures were left for one week aging and then they were subjected to the standard leaching test EN 12457-2. The leachate of tannery waste stabilized with ladle furnace slag showed Cr concentrations below the respective regulation limit value for disposal in non-hazardous waste landfills; however, the dissolved organic carbon cannot meet the respective limit value. On the other hand, the leachate of tannery waste stabilized with a mixture of ladle furnace slag and organoclay, using 30:50:20 mass ratio, presented both Cr and dissolved organic carbon concentrations below the regulation limit values for disposal in non-hazardous waste landfills. Moreover, this leachate was further subjected to ecotoxicity test, using the Vibrio fischeri photo-bacterium. The leachate of stabilized tannery waste showed reduced ecotoxicity, in comparison with the toxicity effect of the leachate of the untreated tannery waste.

Cu Nanoparticles Have Different Impacts in Escherichia coli and Lactobacillus brevis than Their Microsized and Ionic Analogues.

Copper formulations have been used for decades for antimicrobial and antifouling applications. With the development of nanoformulations of copper that are more effective than their ionic and microsized analogues, a key regulatory question is whether these materials should be treated as new or existing materials. To address this issue, here we compare the magnitude and mechanisms of toxicity of a series of Cu species (at concentration ranging from 2 to 250 µg/mL), including nano Cu, nano CuO, nano Cu(OH)2 (CuPro and Kocide), micro Cu, micro CuO, ionic Cu(2+) (CuCl2 and CuSO4) in two species of bacteria (Escherichia coli and Lactobacillus brevis). The primary size of the particles studied ranged from 10 nm to 10 µm. Our results reveal that Cu and CuO nanoparticles (NPs) are more toxic than their microsized counterparts at the same Cu concentration, with toxicities approaching those of the ionic Cu species. Strikingly, these NPs showed distinct differences in their mode of toxicity when compared to the ionic and microsized Cu, highlighting the unique toxicity properties of materials at the nanoscale. In vitro DNA damage assays reveal that both nano Cu and microsized Cu are capable of causing complete degradation of plasmid DNA, but electron tomography results show that only nanoformulations of Cu are internalized as intact intracellular particles. These studies suggest that nano Cu at the concentration of 50 µg/mL may have unique genotoxicity in bacteria compared to ionic and microsized Cu.